6
Using your iron
1. Insert the plug into a 230/240 volt
power outlet and turn the power on.
2. Select the power button to turn the
unit on. The Power On icon illuminates
WHITE as shown in Fig 1, and the unit
beeps once. The boiler and soleplate
will begin heating and the Steam
Ready light illuminates RED.
3. Turn the temperature dial on the iron
to the desired setting (as shown in
Fig 2). Set the temperature to Silk or
above when using steam.
The thermostat light (as shown in
Fig 3) will illuminate AMBER to indicate
that the iron is heating. It will go out
once the iron has reached the selected
temperature.
NOTE:
When changing the temperature
dial from a higher setting to a lower
setting, ensure the iron temperature is
stable at the new setting by allowing the
thermostat to cycle once (the thermostat
light will turn on / off once).
4. Select the desired steam level by
turning the Steam Rate dial to the
desired setting (as shown in Fig 4).
NOTE:
To prevent water dripping from
the soleplate, select the steam setting
that corresponds to the selected iron
temperature as indicated on page 14.
5. When the steam selection illuminates
GREEN, the unit is ready to use.
NOTE:
The Steam Ready light will
illuminate GREEN when the steam can
be activated, usually after 2 ½ minutes.
However, it may take a bit longer for
the steam to be at maximum power
depending on the volume of water in
the boiler and the tank and the ambient
temperature of the water.
Before using the steam generator on
a garment, direct a shot of steam
into the air to release any remaining
condensation.
Using your Pro Glide
®
Steam Generator continued
Figure 1
Figure 2
Figure 4
Figure 3
Summary of Contents for Pro Glide SR8710
Page 1: ...MASTER SERIES Pro Glide Steam Generator User Guide SR8710 SR8700...
Page 17: ...Notes...
Page 18: ...Notes...
