-F7-
-E7-
SPRAY MIST
• The Spray Mist feature is a powerful water spray mist that dampens the
fabric to help remove wrinkles from heavy fabrics and to set creases.
• Press the Spray Mist button firmly to start the spray.
DUAL SHOT OF STEAM
®
This feature allows you to use Shot of Steam
®
while ironing horizontally or
vertically, as the next two sections describe.
SHOT OF STEAM
®
• The Shot of Steam
®
feature provides an extra burst of steam for deep
penetration of stubborn wrinkles. The Shot of Steam
®
feature can be
used with dry or steam ironing provided it has at least a ¼ tank of
water and the Temperature Control Dial is set within the steam band.
• Allow the iron to heat for approximately two minutes.
• Press the Shot of Steam
®
Button several times to prime the pump.
• Press the Shot of Steam
®
Button another three to four times in order to
clean the unit.
• The Shot of Steam
®
feature is now ready for use. The Shot of Steam
®
feature can be used continuously with just a short pause between shots.
The Shot of Steam
®
feature is most effective with the Iron held in a
horizontal position just above the fabric being ironed.
• If the Water Reservoir runs dry, unplug the Iron and refill with water. The
Iron may be filled with water while it is hot. Note: It may be necessary
to re-prime the pump before using the Shot of Steam
®
feature again.
SPRAY
• Le
Spray
est
une
vaporisation
puissante
qui
mouille
le
tissu
pour
aider
à défroisser les tissus épais et pour faire le pli.
• Appuyez
fermement
sur
le
bouton
Spray
pour
commencer
à
vapo-
riser.
FONCTION DOUBLE DE “SHOT OF STEAM
MD”
Cette fonction vous permet d’utiliser “Shot of Steam
MD
” pendant que
vous repassez horizontalement ou verticalement, comme les deux
section suivantes le décrivent.
SHOT OF STEAM
MD
• La
fonction
“Shot
of
Steam
MD
” produit un jet de vapeur puissant
pour pénétrer en profondeur les plis rebelles. Cette fonction sert au
repassage à sec ou à la vapeur lorsque le réservoir est rempli d’eau
au moins au quart et que le cadran du régulateur de température est
positionné dans la plage des températures de la zone vapeur.
• Permettez
au
fer
à
vapeur de
chauffer
pendant
deux
minutes.
• Appuyez
plusieurs
fois
sur
le
bouton
“S
hot
of
St
eam
MD
” pour inicier la
pompe.
• Appuyez
sur
le
bouton
“Shot
of
Steam
MD
” environ trois ou quatre fois
pour nettoyer les orifices.
• La
fonction
“S
hot
of
St
eam
MD
” est désormais prête à utiliser en continu
avec des petits intervalles entre chaque jet de vapeur
. Cette fonction
est le plus efficace lorsque vous tenez le fer en position horizontale tout
en laissant un petit écart juste au-dessus du tissu à repasser.
• Lorsque
le
réser
voir d’eau
s’épuise,
débranchez
le
fer
et
remplissez
le réservoir
. Vous pouvez remplir le fer d’eau lorsqu’il est chaud.
Remarque: il se peut que vous deviez réinitialiser la pompe avant
d’activer à nouveau la fonction “Shot of Steam
MD
”.
Summary of Contents for GCSBBS5806
Page 12: ...E12 NOTES...