![background image](http://html1.mh-extra.com/html/sunbeam/em4800c-cafe-crema/em4800c-cafe-crema_instruction-booklet_1393610015.webp)
13
Before using your Sunbeam Café Crema
™
for the first time or if you have not used it
for some time, rinse the machine by running
water through without coffee in the filter
holder, as follows:
Note:
Throughout these instructions the
numbers you see highlighted and in brackets
refer back to the diagrams at the start of this
instruction manual.
• Open the lid of the water reservoir
(1)
and
fill with cold water
(2)
. Alternatively you
can open the lid and remove the water
reservoir using the handle
(3)
. Then fill
with cold water
(4)
.
• Replace the water reservoir firmly into the
unit
(5)
and close lid.
• Insert the power cord into a 230-240V AC
power outlet and turn the power on. Start
the unit
(6)
. The red ‘Power’ light and
‘Warm Up’ light will both illuminate.
• Place one of the filters in the filter handle
(7)
. Then position the filter handle on the
machines brewing head.
• To ensure that the filter handle is in
the correct position, turn the handle so
it points to the left and place the filter
handle flat against the brewing head
(8)
,
then turn the handle towards the right
(9)
,
as far as it can go.
Note:
Do not over tighten.
• Place a sufficiently large container under
the brewing head
(10)
.
• As soon as the orange ‘Warm Up’ light
goes off, turn the operating dial to the
setting
(11)
and allow all the water in the
water reservoir to run through.
• If necessary, you may need to stop the
operation by turning the operating dial to
the ’Off’ position, empty the container,
then resume the operation.
Note:
Make sure that the water reservoir
is clean and free of any debri, as any fine
particules can block the water flow.
Before using your Café Crema
™