6
READY TO USE
Note:
The
BATTERY INSTALLATION
and
COLLAR FITTING
steps must be
completed before you are ready to use.
STEP 1:
Holding the main body of the Sunbeam® Advanced Remote Trainer
in both hands PRESS and HOLD the Main Control Button for 4 seconds.
Note:
You will hear 2 audible beeps and 3 LEDs flash gREEN indicating the
device is on.
STEP 2:
Set correction level by pressing and holding (approximately 2 seconds) the
Main Control Button until a gREEN LED illuminates at the desired setting.
When a gREEN LED is illuminated press the Main Control Button once to
toggle to the next correction level. Once a correction level is chosen all
3 gREEN LEDs will illuminate every 10 seconds to advise the unit is on.
IMPORTANT:
Always make sure to turn off the collar when not in use to
conserve battery life.
Note:
It is recommended to start on the
LOW
setting and monitor your
dog’s behavior before determining if a higher correction level is needed. The
Sunbeam® Advanced Remote Trainer retains the last correction level setting
and will resume this mode when the unit is turned on.
STEP 3:
Attach collar to your dog as you did in the
COLLAR FITTING
stage.
STEP 4:
Turn on the remote control by pressing the On/Off button for 2 seconds.
STEP 5:
To begin using the remote trainer, find your dog’s recognition level
starting with the warning button. Once an unwanted behavior takes place, such
as chewing, digging, barking, jumping, biting or whining, immediately press the
warning button. Each dog will react differently and reactions may include a dip of
the head, shaking the head, whining, excessive barking or confusion. Some dogs
will respond to the warning button and stop the unwanted behavior. If this is the
case, continue training your dog using the warning button and skip to STEP 7.
IMPORTANT:
Your timing on this step is crucial. If the unwanted behavior
has stopped before you have time to press the warning or correction button,
DO NOT press the warning or correction button. The warning or correction
button should only be used at the exact moment the unwanted behavior is
taking place.
STEP 6:
If the dog does not respond to the warning button, starting on the LOW
setting, press the correction button. If your dog does not respond to the correction
on the LOW setting, toggle the collar setting to MEDIUM and HIgH, if necessary.
STEP 7:
Once your dog’s recognition level has been identified, continue training
with that setting. As soon as the unwanted behavior stops, be sure to reward your
dog with praise, petting or a treat.
