Sun Microsystems SunSwift SPARCserver 1000, Installation Manual, Page: 33 / 70

Setting Up the System 2-3
2
Figure 2-2 AC Power Switch and Power Receptacle
Caution – Do NOT turn on power to the unit yet. To do so could cause system
damage to occur.
2.4 Connecting the Network Cable to the Server
The main network interface is incorporated directly on the system board
installed in slot 0 (top slot). To connect the server side of the network cable:
1. Locate a transceiver cable with two RJ-45 connectors.
Figure 2-3 shows one style of Ethernet cable.
Figure 2-3 Transceiver Cable
2. Plug one end of the transceiver cable into the Ethernet port.
The Ethernet port is located on the lower right side of the system board in
card cage slot 0. See Figure 2-4.
AC power switch
AC connector
!