Sun Microsystems SunSwift SPARCserver 1000, Installation Manual, Page: 32 / 70

2-2 SPARCserver 1000 System Installation Manual—June 1996
2
2.2 Preparing the System for Cabling
Ensure the server is placed on a surface affording access to both the front and
the rear of the chassis. This site should conform to site preparation guidelines
and specifications covered in Chapter 1, Section 1.6, “Site Preparation.”
2.3 Connecting the Power Cord
1. Insert the key provided with your system into the front panel key switch.
Turn it to the Standby position (fully counterclockwise).
See Figure 2-1.
Figure 2-1 Key Switch Positions
2. Turn the AC power switch to Off.
This switch is in the upper left corner of the system rear. See Figure 2-2.
3. Plug the female end of the power cord into the AC connector.
This connector is in the lower left corner of the system rear. See Figure 2-2.
4. Plug the male connector on the power cord into a grounded wall outlet.
The outlet must be a 110-240 VAC 15A circuit.
Standby
On
Diagnostics
Locked