Sun Microsystems SunSwift SPARCserver 1000, Service Manual

Page: 138 / 218

10-8 SPARCserver 1000 System Service Manual—June 1996
10
▼
SuperSPARC Module A
1. Unlock four standoffs securing the module to the system board.
Pull up the tip insert of each standoff to unlock. See Figure 10-3.
2. Hold the module by the edges near the connector and carefully loosen the
connector from the socket.
Caution – The connector housing will break if the module is tilted too far.
3. Place the module in an antistatic bag.
▼
SuperSPARC Module B
SuperSPARC module B mounts like an SBus card: the connector end rests on
standoffs, but the back panel slides onto the lip of a back panel filler plate.
1. Unlock four standoffs securing the module to the system board.
Pull up the tip insert of each standoff to unlock. See Figure 10-3.
2. Hold the module by the edges near the connector and gently loosen the
module from the socket.
3. Lift the module from the socket at an angle while guiding the other side
of the module out from the back panel filler.
See Figure 10-5. Each module hole rests on a small pin. Gently free the
module from the back panel filler.
Note – It may be necessary to remove SuperSPARC Module A or the SBus card
in slot 1 to get a firm grip on SuperSPARC Module B. A firm grip is necessary
to remove the module from the connector without breaking the connector.
4. Place the SuperSPARC Module in an antistatic bag.
!