Sun Microsystems SunSwift SPARCserver 1000, Service Manual

Page: 113 / 218

Storage Devices 9-5
9
9.2.2 Replacement
Note – Verify the device ID is correct before replacing the drive. Set it if
necessary. For the correct address and configuring instructions, refer to
Appendix E, Section E.4, “Selecting Drive ID Numbers in the SCSI Tray.”
1. Slide the tape drive into the 5 1/4-inch device bracket.
2. Set the SCSI ID jumpers.
3. Install four screws to secure the drive to the bracket.
4. Slide the 5 1/4-inch device bracket (with tape drive installed) into the
SCSI tray assembly, from the front, and install two retaining screws.
See Figure 9-1.
5. Reconnect the power and SCSI-2 cables at the drive rear.
9.3 Disk Drive
9.3.1 Removal
The disk drives reside on two small disk drive brackets mounted on the SCSI
tray right side. Either bracket can be removed without disturbing the other.
1. From the front of the SCSI tray assembly, disconnect the cables from the
disk drive bracket you are planning to remove.
Label the cables for easy identification during replacement.
2. Turn the SCSI tray around so the tray rear faces you.
The disk drive brackets are now on your left.
3. Remove two screws securing the drive bracket to the SCSI tray assembly.
See Figure 9-4.
4. After the screws are removed and set aside, pull the drive tray towards
you until it is completely free of the SCSI tray assembly.
5. Invert the drive tray so the mounting plate faces up.
See Figure 9-5.