Sun Microsystems SUN BLADE 150, Service Manual

Page: 14 / 218

xiv Sun Blade 150 Service Manual • June 2002
FIGURE 7-2
Removing the Diskette Drive 7–3
FIGURE 7-3
Removing and Replacing the Smart Card Reader 7–5
FIGURE 7-4
Removing and Replacing a Primary Hard Drive 7–7
FIGURE 7-5
Installing a Secondary Hard Drive 7–10
FIGURE 7-6
Secondary Hard Drive Cabling Configuration 7–11
FIGURE 7-7
Removing and Replacing a CD-ROM or DVD-ROM Drive 7–12
FIGURE 8-1
Removing and Replacing the CPU 8–3
FIGURE 8-2
JP3 OpenBoot PROM Jumper Settings for 650 MHz and 550 MHz CPUs 8–4
FIGURE 8-3
Removing and Replacing the NVRAM/TOD 8–6
FIGURE 8-4
DIMM Installation Order 8–8
FIGURE 8-5
Removing and Replacing a DIMM 8–9
FIGURE 8-6
Removing and Replacing a PCI Card 8–11
FIGURE 8-7
Removing and Replacing the Motherboard 8–14
FIGURE 8-8
JP1/JP2 Jumper Settings for the Flash PROM 8–15
FIGURE 8-9
Removing and Replacing the Riser Board 8–17
FIGURE 9-1
Replacing the System Cover 9–2
FIGURE 9-2
System Power Switch 9–2
FIGURE A-1
Minimum Clearance for System Cooling A–4
FIGURE A-2
IDE Cabling Configuration A–5
FIGURE A-3
External and Internal Serial Ports A–7
FIGURE B-1
Power Supply Connector J501 Pin Configuration B–2
FIGURE B-2
Secondary Power Supply Connector J505 Pin Configuration B–3
FIGURE B-3
USB Connector J17, J18 Pin Configuration B–4
FIGURE B-4
IEEE 1394 Connector J20, J30 Pin Configuration B–5
FIGURE B-5
TPE Connector J19 Pin Configuration B–6
FIGURE B-6
Serial Port Connector J36 Pin Configuration B–8
FIGURE B-7
Riser Board Serial Port Pinouts (J13) B–9
FIGURE B-8
Accessing the Second Serial Port Through a PCI Card Slot B–10
FIGURE B-9
Serial and Video Port Connector Extensions B–11
FIGURE B-10
Parallel Port Connector J9 Pin Configuration B–12