Sun Microsystems SUN BLADE 150, Service Manual

Page: 111 / 218

Chapter 7 Removing and Replacing Storage Devices 7-3
FIGURE 7-2
Removing the Diskette Drive
7.1.2 Replacing the Diskette Drive
1. Position the diskette drive into the peripheral assembly (
FIGURE 7-2
).
2. Using a No. 2 Phillips screwdriver, replace the three screws securing the diskette
drive to the peripheral assembly.
3. Position the peripheral assembly into the chassis, aligning the three holes on the
assembly with the three screws on the chassis (
FIGURE 7-1
)
4. Slide the peripheral assembly forward until it stops.
5. Using a No. 2 Phillips screwdriver, tighten the three screws securing the
peripheral assembly to the chassis.
6. Connect the following:
■
Diskette drive data cable
■
Diskette drive power cable
■
Smart card reader power cable
Note –
Ensure that the cable assembly connectors are properly oriented by aligning
the connector keys.
7. If you removed any PCI cards, reinstall them on the riser board.
See Section 8.4.2, “Replacing a PCI Card” on page 8-11.
8. Detach the wrist strap, replace the system cover, and power on the system as
described in Chapter 9.