Sun Microsystems StorageTek SG-XPCIE1FC-QF8-Z, Installation Manual

Page: 25 / 68

Chapter 2 Hardware Installation and Removal 15
FIGURE 2-3
Connecting the Optical Cable: Dual Port HBA
2. Connect the other end of the cable to the FC device.
After the optical cable is connected to the HBA, you can power on the system.
▼
To Apply Power
1. Verify that the HBA is securely installed in the system.
2. Verify that the correct fiber-optic cable is attached.
3. Refer to your system installation or service manual to determine how to power
on the system.
4. Observe the light-emitting diode (LED) status for the power-on self test (POST)
results as shown in
TABLE 2-1
.
The yellow, green, and amber LEDs can be seen through openings in the
mounting bracket of the HBA.
TABLE 2-1
summarizes the LED status conditions.