Sun Microsystems StorageTek 5320, Getting Started Manual

Page: 111 / 226

Chapter 4 Installing the Sun StorageTek 5320 NAS Cluster Appliance 91
▼
To Power On the Sun StorageTek 5320 NAS
Cluster Appliance System
1. Verify that all cables between the Sun StorageTek 5320 NAS Cluster Appliance,
controller enclosures, and expansion enclosures are properly secured according to
the instructions in
“Connecting the Sun StorageTek 5320 NAS Cluster Appliance to
Controller Enclosures” on page 76 and “Connecting the Controller Enclosures to
Expansion Enclosures” on page 81 .
2. Verify that the Cat5 Ethernet cable is connected between the heartbeat ports
according to the instructions in “Connecting the Server Health-Monitoring and
Network Cables” on page 88 .
3. Power on each expansion enclosure by setting the two power supply switches to
the On position.
4. Check that all LEDs on the expansion enclosure front panels turn solid green to
indicate good operation.
Note – If the expansion enclosure contains SATA disk drives, only the Power LED
turns solid green. The drive LEDs turn solid green only after the controller enclosure is
powered on.
5. Power on each controller enclosure by setting the two power supply switches to
the On position.
6. Check that all LEDs on the controller enclosure front panels turn solid green to
indicate good operation.
7. Verify that the Sun StorageTek 5320 NAS Cluster Appliance is connected to the
network.
Note – Power up and configure one server at a time.