Sun Microsystems 15K/9960, Site Planning Manual

Page: 43 / 70

Chapter 5 Network Planning 23
The following table contains the user community and IP address for the SCs. These
settings are set when you configure the system controllers.
Additionally, a logical interface is required for the SCs for each user community.
Logical interfaces are only present on the main SC. SC pathgroup-specific IP
addresses are also required when using an HA configuration (refer to the Sun Fire
15K Site Planning Guide for more information). Use the following table contains to
record the logical interfaces. These interfaces are set when you configure the SCs.
Note –
The logical and pathgroup-specific IP address for a community must use the
same IP network and subnet as the physical NIC(s) in that community.
TABLE 5-5
Community Host Name IP Addresses for the System Controllers
Cx Network
Interface User Community IP Address
Server 1, system controller 0, Ethernet
Server 2, system controller 0, Ethernet
Server 1, system controller 1, Ethernet
Server 2, system controller 1, Ethernet
TABLE 5-6
Host Name IP Addresses for the SC Logical Interface
User Community Logical Host Name
Logical IP
Address SC0 Pathgroup IP
Address SC1 Pathgroup IP
Address
Server 1, User
Community A
Server 2, User
Community A