Operation manual of SR528Q wireless controller
- 18 -
even when the tank temperature drops to the switch
–on temperature of heating.
Note:
When there is no sensor installed in the top part of tank (no T3 sensor),
controller will take the signal of T2 (sensor in bottom of tank) automatically to
control this function.
The time in this controller is 24 hours mode, when you set schedule, the
switch-off time of heating should be larger than switch-on time. For example: if
you set the switch-on time of heating is at 17:00, but switch-off time of heating is
6:00, then this setting doesn’t take effect, that means within this time section,
heating function doesn’t work. The correct set is like flowing: it should be
divided into two time sections, one time section is from 17:00 to 23:59, the other
time section is from 00:00 to 06:00.
Setup steps:
under standby status,
► Press “
Heating” button to enter the timing setup interface, “
tH 1o 04:00
” shows on
the screen, access the submenu of the switch-on time
and temperature for the first schedule of heating
function.
► Press “Set” button, hour “04” blinks on the screen, the switch-on time and temperature for
the first schedule of heating function can be set.
►Press “
▲ ▼
” button to adjust hour of time.
►Repress “Set” button again, minute “00” blinks on the screen.
►Press “
▲ ▼
” button to adjust minute of time.
►Repress “Set” button, temperature “40
o
C” blinks on the screen.
►Press “
▲ ▼
” button, to set the switch-on temperature of heating.
►Then, press “Esc” to exit this submenu.
-----------------------------------------------------------------------------------------------------------------
►
Press “
Heating” button, “tH 1F 05:00” shows on the screen, access the submenu of
the switch-off time and temperature for the first
schedule of heating function.
► Press “Set” button again, hour “05” blinks on the
screen.
►Press “
▲ ▼
”button to adjust hour of time.
►Repress “Set” button again, minute “00” blinks on the screen.