14
UP
Used to increase (warm) the set temperature by 1°C/1ºF.
DOWN
Used to decrease (cool) the set temperature by 1°C/1ºF.
Indicator Light
The indicator light is the decimal point located at the right lower corner of the display. The indicator
light will be on when a multi-key function is selected. To perform a multi-key function, press and
hold the first key, then press the second key for at least 5 seconds and then release both keys
.
ºF/ºCSelector
Select the temperature display setting in Fahrenheit or Celsius degree. To change the temperature
from Fahrenheit to Celsius or from Celsius to Fahrenheit, press and hold the
LIGHT
key for 5
seconds.
Setting the Temperature Control
The unit has two separate temperature zones. The temperature of both zones can be set
between 41ºF and 72ºF(5ºC and 22ºC). It can be used as a wine maturing cabinet or a wine
serving cabinet. For maturing wine, the recommended temperature setting ranges of both zones
should be between 52ºF and 57ºF (11ºC and 14ºC). For serving wine, the recommended
temperature setting range of the
UPPER
zone should be between 41ºF and 50ºF (5ºC and
10ºC) which is ideal for serving champagne & white wine, and the recommended temperature
setting range of the
LOWER
zone should be between 58ºF and 72ºF (15ºC and 22ºC) which is
ideal for serving red wine.
When the unit is plugged in for the first time, the unit will power up automatically to the preset
defaults. The preset temperature at the factory for the
UPPER
temperature zone is 50ºF (10ºC)
and for the
LOWER
temperature zone is 60ºF (16ºC).
You can press the left side
UP
and
DOWN
keys to control the internal temperature of the
UPPER
temperature zone and press the right side
UP
and
DOWN
keys to control the internal
temperature of the
LOWER
temperature zone. When you press the two keys at the same time,
the display will show the last temperature set previously.
NOTE:The temperature set for the LOWER temperature zone must always be just as high
as or higher than that in the UPPER temperature zone. For optimal performance, the set
temperature of the two zones should differ by at least 8F°.
The temperature that you desire to set will increase 1ºC or 1ºF if you press the
UP
key once; on
the contrary the temperature will decrease 1ºC or 1ºF if you press the
DOWN
key once. The
display flashes while you make the setting.
After the temperature has been set, the display shows the current inner temperature of the
particular temperature zone.
To view the set temperature at any time, press the
UP
or
DOWN
key; the set temperature will
temporarily flash in the display for 5 seconds. Then the display shows the current inner
temperature again.
NOTE:
If the unit is unplugged, or power is lost or turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the unit will not start.
When you use the unit for the first time or restart the unit after it has been shut off for a long
time, there could be a few degrees variance between the temperature you select and the one
indicated on the LED readout. This is normal and is due to the length of the activation time.
There should not be a problem once the unit has been running for a few hours.
