11
10. Recheck and adjust the lower door alignment by loosening the screws (6) & (7) and moving the door
adapter (5) & (8). Tighten the screws (6) & (7) after the door is levelled. (Fig. 5)
11. Transfer the handles and plugs to the opposite positions. (
See page 13
. Handle Installation)
-
Model SWC1102/SWC1926/SWC1966
3
9
6
7
3
4
5
4
1
2
1
1. Remove the plastic cover (1), then remove the bottom hinge (3) by unscrewing the four lock screws
(2). Be careful to hold the glass door firmly after removing the screws. (Fig. 1)
2. Gently pull down to remove the glass door from the right top hinge and place it on a padded surface to
avoid the risk of damage. Then remove the right top hinge (8). (Fig. 4)
3. Pop out the cover caps on the left side of the cabinet and use them to cover the screw holes on the
right hand side.
4. Screw the alternative left top hinge (7), included in the fittings,
on the left hand side of cabinet. (Fig. 4)
5. Unscrew and transfer door supporter (9) to the opposite side. (Fig. 5) At the same time remove the
stopper pin (6) of bottom hinge to the opposite designated position. (Fig. 3)
6. Unscrew and transfer the door adapter (4) to the left designated position of the glass door. (Fig. 2)
7. Relocate the glass door to the designated position.Then screw the bottom hinge on the left designated
position and tighten it. (Fig. 5)
8. Recheck and adjust the door alignment by loosening the two screws (5) and moving the door adapter
(4). Tighten the two screws (5) after the door is levelled. (Fig. 5)
9. Remove the handle from the left side of the door and install it on the right side.(
See page 13
.)
