SummaSign Pro T-series Cutters
User’ s Manual
Operation
2-12
2.3.5. POUNCING GAP
The pouncing gap submenu is used to set or modify the distance between the
pounced wholes. This routine applies to the pouncer only.
The default pouncing gap value is 0 mm.
The value can be set between o and 50 mm.
On the LCD, the active pouncing gap value is marked with an *.
2.3.6. VELOCITY
The VELOCITY submenu is used to set or modify the velocity of the tool.
The default velocity is 800 mm/s (32 ips).
The velocity can be set between 50 mm/s (2 ips) and 1000 mm/s (40 ips).
2.3.7. OVERCUT
The OVERCUT submenu enables you to generate an overcut in order to
facilitate weeding the cut.
The default overcut is set to 1.
The overcut setting can be disabled (=0) or set to any value between 0(=off)
and 10. One unit is about 0.1 mm or 0.004 ".
On the LCD, the active value is marked with an *.
2.3.8. SYSTEM SETUP
The SYSTEM SETUP submenu covers the menu items you normally only need
when establishing the initial setup e.g. when you install the cutter in
combination with the software you use.
Press the
key to access the different submenu items, which are explained in
Summary of Contents for T1010 Pro
Page 1: ......
