SummaSign Pro T-series Cutters
User’ s Manual
Operation
2-9
2.3. THE USER CONFIG MENU
The USER CONFIG(uration) menu gives access to different submenus which
allow you to configure the cutter’ s operating parameters. It should be taken
into account that access to some of the submenus will be determined by the
plotting language you are using.
Four different user configurations can be saved. The selected configuration
number is displayed on the LCD next to the USER CONFIG message. These four
USER CONFIG 1(->4) menus are maintained independently.
è
To select another
configuration number
, proceed as follows:
1.
Power on the cutter.
2.
Press the
key until USER CONFIG 1(->4) is displayed.
3.
Press the
or
jogging key until the desired configuration number is
displayed next to USER CONFIG.
NOTE
Before altering any of the items in the USER CONFIG menu, make sure
that you have previously selected the right configuration number in
the USER CONFIG 1(->4) menu.
Figure 2-3 shows the USER CONFIG submenus.
è
To select and alter a configuration parameter, proceed as follows:
1.
Power on the cutter.
2.
Press the
key until USER CONFIG 1(->4) is displayed.
3.
Press the
or
jogging key until the desired submenu is displayed
on the first line of the LCD.
4.
Press the
or
jogging key until the desired value is displayed on
the second line.
5.
Press the
key to confirm the selection, an * will be displayed next to
the selected setting. (An * is always displayed next to the active value. )
Summary of Contents for T1010 Pro
Page 1: ......
