Installation and Operating Instructions
Lifting unit type ABS 5 kN
GB 0503-E
9
4
Assembly and reassembly of the lifting unit
Before first assembly all parts have to be checked whether they are all available and correct according to the
parts list. Before first operation of the assembled unit including support it has to be inspected by an expert. A
written report on this inspection is required. (See attached check list.)
11
9
10
6
7
8
7
7
7
6
6
4
3
2
1
5
7
14
13
12
15
6
B
A
0503-0005
Legend
1 Lifting device support
2 Lower bearing
3 Upper bearing
4 Post
5 Handle grip
6 Bolt
7 Security pin
8 Boom
9 Weight (Accessory)
10 Pulley
11 Slot of pulley frame
12 Rope winch
13 Winder
14 Winch fixing plate
15 Boom locking
Figure 4 Assembly/reassembly of the lifting unit
Assembly
•
Insert the post (4/4) into the lifting device support (4/1).
•
Interlock the boom (4/8) with the post (4/4) by inserting and securing the first bolt (4/6) into the lowest drilling
of the resp. boom locking with a security pin (4/7).
•
Tilt the boom upwards until the second bolt (4/6) can be inserted and secured with a security pin (4/7).
•
Connect the winch plate (4/14) with the winch (4/12) according to the instructions of the winch manufacturer.
•
Attach the winch to the boom (4/8) with the third bolt (4/7) and secure the bolt with a security pin.
•
Connect the wire rope to the winch drum according to the manufacturer’s instructions. Pull the wire rope
through the slot of the pulley frame (4/11) on to the pulley (4/10). Wind the wire rope tightly on to the winch
drum.
•
The wire rope has to be long enough to keep at least three turns on the winch drum in the lowest position of
the load.
•
Adjust the angle of the boom according to the required overhang and load.
