Sullair 02250165-411 R01, User Manual

Page: 15 / 48

Section 3
15
WS CONTROLLER USER INTERFACE MANUAL
ADJUSTMENTS
3.1 INTRODUCTION
This section describes steps for using the WS
Controller to modify specific parameters that control
the machine operation.
Typically, the top line of the Controller Display
Screen will display the line pressure and compressor
temperature; the bottom line will display the current
operating mode. As the user presses the down
navigation arrow, the screen will display various
machine statistics appearing under the heading
“Compressor Status”. These values are not
adjustable at the WS Controller. Navigating past
these screens, the first line of the screen will display
the words “Show Settings-------“. This indicates that
the controller is in the Adjustment mode. When in
Adjustment mode, control parameters will be
described in the second line of the display screen.
These control parameters can be modified by the
user. The bottom line of the display will show the
current value or setting of the control parameter.
Section 3.2 provides general steps to modifying the
compressor control parameters. A description of
each user modifiable parameter is provided in
Section 3.3 .
3.2 COMPRESSOR
ADJUSTMENT
PROCEDURES
The following steps apply while “Show Setting------- “
is indicated in the display. The control parameter
described in the display can be modified by the user.
Use these steps to modify a parameter value:
1. Press the UP arrow or DOWN
arrow pad on the controller panel to navigate
to the parameter to be change.
2. Press the ENTER pad to select the
parameter and access the CHANGE mode.
The change mode is indicated by the text
“Change Setting -------” appearing in
(negative) characters on the top
line of the display. The parameter name will
appear on the second line and the current
parameter value or setting will appear in
characters on the bottom line.
3. Use the UP arrow or DOWN arrow
pad to change the value or mode of the
parameter.
4. When the desired value or mode name
appears on the display, Press ENTER
to accept and save this new value for the
selected parameter. The display will return
to the ADJUSTMENT view and the new
value or mode will be displayed.
NOTE
Control parameters described in this
manual are those which can be adjusted
via the WS controller. Additional parame-
ters that control the operation of the com-
pressor and sequencing of multiple
machines can be viewed and edited using
the WSPC Software program. See the
WSPC User Interface Manual for more
details.
reverse
reverse