Sullair 02250165-411 R01, User Manual

Page: 13 / 48

SECTION 2 WS CONTROLLER USER INTERFACE MANUAL
13
8. Open the shut-off valve to the service line.
9. After operating the machine for 24 hours,
inspect the compressor for fluid leaks and
proper operating temperature.
SUBSEQUENT START-UP PROCEDURE
1. On subsequent start-ups, check the fluid
sight glass for proper fluid level. Service if
necessary. See compressor Operator’s
Manual.
2. Press the START pad on the display
screen. The machine will prepare to start up
in the last operating mode existing at shut-
down. The current Machine mode will
appear on the display screen.
3. If a different operating mode is desired, use
the arrow pads to navigate to the Mode
parameter. Press the ENTER pad to
enter the Change Mode. Navigate to the
desired mode (Automatic or Manual). Press
the ENTER pad to accept and save
the mode setting.
4. When the compressor is running, observe
the display panel and maintenance indica-
tors to ensure the values displayed are
within the proper ranges.
2.4 SHUTDOWN PROCEDURE
Shut down the compressor by pressing the STOP
pad on the WS Controller panel.
NOTE
The system may require sump blowdown
(typically below 10 psi) to be completed
prior to restarting.
WARNING
The compressor may restart automatically
after a power failure or after the E-Stop but-
ton has been reset.