Suisei EFP-LC, Supplementary Manual, Page: 5 / 24

（
5/24
）
EFP-LC TypeE Supplementary manual
(For RX66T)
5.2
Collision prevention circuit example
An example of collision prevention circuit when user peripheral circuit outputs is shown Fig5..
※
プログラム時ジャンパを外す。
*Disconnect jumper when programming.
Fig5.2 Collision Prevention Circuit Using Jumper
5.3
Handling of mode Pins
For the RX66T series, implement the terminal treatment of the mode terminal as shown in Table 5.1.
When the handling of the Mode pins is not possible on a user target board, connect the T_BUSY pin of EFP -LC to the
mode pin of MCU.
Table5.1 Handling of mode pins
MCU series name
Mode pin
name
Pin handling
pin handling in EFP-LC
Signal name
（
4-wire Cable Pin No.
）
RX66T
MD L T_BUSY (3)
P00 L T_BUSY (3)
*: L connects with GND