SUHNER MACHINING BEM 6, Technical Document

Page: 29 / 52

Air connection inner diameter 4mm
Air consumption per cm stroke 0.08 l
Tool hoder: Collet chuck ER16
Sleeve mount DIN 55058 ST16
Running trueness 0.02mm
Maximum speed 10000min- 1
Working speed
50Hz 2900min
-1
0.37kW 1090-7730min
-1
50Hz 1450min
-1
0.37kW 550-3870min
-1
60Hz 3500min
-1
0.44kW 1300-9280min
-1
60Hz 1750min
-1
0.44kW 660-4650min
-1
Type of motor protection IP 55
Motor output rating 0.37kW/0.44kW
Motor speed rating 50Hz 2‘900min
-1
/1450min
-1
System voltage 230/400/460V, 50Hz
Weithg 16kg
Paint coating
RAL5012
2.5 O
perAting cOnditiOns
Temperature range during operation: +20 to +50°C
Maximum relative air humidity: 90% at +30°C, 65% at
+50°C
Compressed air: 5-7bar
Compressed air for pneumatic according to DIN ISO
8573-1 [5/4/4]
Handle tools with caution; keep tools in clean and
sharp condition and observe the tool manufac-
turer’s instructions with regard to the use of cool-
ants and tool holding devices.
Use rotational and advance speeds which are assigned
to the tool and to the material.
2.6 s
AFety instructiOns tO Be OBserVed On
cOmmissiOning
Before all work on the machine, it must
first be disconnected from the power sup-
ply.
Only a qualified person familiar with the safety regulations
may start up the machine.
Always conduct test runs without workpieces.
Check the sense of rotation before starting the machine.
The operator must make sure that the components are
integrated and operate safely in the machine.
Only a qualified person may connect the electrical power
supplies in accordance with the local regulations.
The local grounding regulations must be observed and
implemented, and this implementation inspected.
Do not start the machine until the spindle has come to a
stop.
Use only suitable tools, and never modify tools for an ap-
plication they have not been designed for.
After transport, all electrical and mechanical connections
must be examined for damage and loosening, and any
remedial measures taken.
The machine’s working area must be unobstructed and
secured against unauthorized access.
When internal cooling is used, please observe the instal-
lation instructions issued by the manufacturers of the at-
tachment and rotating union.
The motor’s and spindle’s sense of rotation may be
checked only when there is no tension in the belt. Cor-
recting a wrong sense of rotation involves swapping over
any two of the phase conductors.
The motor cable’s shielding must be connected to the
motor housing over a large area at the terminal board.
3. h
anDling
/o
PEration
3.1 m
Achine
3.1.1 c
hAnging tOOthed pulleys
Bring machine to complete standstill.
Loosen the screws and remove the cover.
Loosen screws (1). Lower motor with adjusting screw (2).
29
P
ortugúes
Español
Italiano
English
F
rançais
Deutsch
English