Suburban SW10D, Service Training Manual

Page: 9 / 44

inStallatiOn uSing raDiuS FraMe anD DOOr
(4 and 6 Gallon Only)
A. Position heater into framed opening as illustrated.
B. On mesa or yoder type sidewalls, flatten the wall area around the opening.
C. Caulk around framed opening (trailer skin) as illustrated in Figure 3.
D. Apply a bead of silicone caulking (or suitable caulking) around the inner edge of the control housing. See detail “A” in
Figure 3. This will seal the frame to control housing.
E. Apply a bead of silicone caulking (or suitable caulking) around back side of door frame. See detail “A” in Figure 3. This
will seal frame to coach skin.
F. Fit the door frame into control housing (over the caulking already applied) and pull frame tight to control housing using
the three (3) No. 8-15 x 3 1/2” screws provided.
G. Push water heater into framed opening until back side of door frame is against the side of the coach and firmly attach
with screws around the perimeter of the frame. NOTE: The two holes in bottom of frame identified as “A” in Figure 3 are
also used to mount door hinge to the frame.
H. Install chocks, one on each side of water heater, as illustrated in Figure 1A.
I. Attach door to frame as illustrated in Figure 3.
J. Close the door so that the door latch protrudes through the slot in the door. Turn latch 90 degrees to fasten door shut.
A
FRAMED OPENING
DETAIL A
SPECIAL SCREW
CONTROL HOUSING
GASKET
DOOR LATCH
RADIUS CORNER DOOR FRAME
CONTROL HOUSING
HINGE ROD
RADIUS CORNER DOOR
SILICONE CAULKING INNER EDGE OF
CONTROL HOUSING
CAULK AROUND OPENING
TO SEAL CONTROL HOUSING
TO SKIN, WATER TIGHT
FRAMED OPENING
(SEE FIGURE NO. 1)
EXTERIOR
COACH SKIN
CAULK ALL THE WAY AROUND DOOR FRAME TO
SEAL FRAME TO COACH WALL, WATER TIGHT
(SEE DETAIL A)
MOUNTING SCREWS, FRAME TO COACH WALL
(11) REQ'D.
MOUNTING SCREW (SPECIAL)
DOOR FRAME TO CONTROL HOUSING
(3) REQ'D.
SILICONE CAULKING
DOOR FRAME
MOUNTING SCREW
AC JUNCTION BOX
MODEL: SW6DE,
PE, PER
DC JUNCTION BOX
MODELS: SW4D, SW6D,
SW6DE
Figure 3
9
DC JUNCTION BOX
MODELS: SW4D, SW6D,
SW6DE, SW6DEL
AC JUNCTION BOX
MODELS: SW6DE, PE,
PER, SW6DEL