Subaru Tribeca 2012, Quick Reference Manual

Page: 398 / 578

Black plate (243,1)
北 米
Model "A3170BE-A" EDITED: 2011/ 7/ 12
opener by pressing the programmed
HomeLink
®
button.
&
Programming other devices
To program other devices such as door
locks, home lighting and security systems,
contact HomeLink at www.homelink.com
or call 1-800-355-3515.
&
Operating the HomeLink
®
Wireless Control System
Once programmed, the HomeLink
®
Wire-
less Control System can be used to
remote-control the devices to which its
buttons are programmed. To activate a
device, simply press the appropriate but-
ton. The indicator light illuminates, indicat-
ing that the signal is being transmitted.
&
Erasing HomeLink
®
button
memory
NOTE
.
Performing this procedure erases
the memory of all the preprogrammed
buttons simultaneously. The memory
of individual buttons cannot be erased.
.
It is recommended that upon the
sale of the vehicle, the memory of all
programmed HomeLink
®
buttons be
erased for security purposes.
1. Press and hold the two outside buttons
until the indicator light begins to flash
(after 10 seconds).
2. Release both buttons.
&
In case a problem occurs
If you cannot activate a device using the
corresponding HomeLink
®
button after
programming, contact HomeLink at
www.homelink.com or call 1-800-355-
3515 for assistance.
Rear view camera (if
equipped)
A rear view camera is attached to the rear
gate. When the ignition switch is
“
ON
”
and
the select lever is set to
“
R
”
, the rear view
camera automatically displays the rear
view image behind the vehicle on the
navigation monitor or on the inside mirror.
WARNING
.
Since the rear view camera uses
a wide-angle lens, the image on
the monitor is different from the
actual view in terms of distance.
.
Since the range of the image on
the monitor is limited, you should
always check the rear view and
Interior equipment
6-21
–
CONTINUED
–
6