Subaru 2003 Outback Sport, Owner'S Manual

Page: 237 / 418

IMPREZA(NA) A1850BE-A (ENGLISH)
Starting and operating
7-8
mination is observed, there is no stored diagnostic
trouble codes, and the OBD system readiness moni-
tors are complete.
D
A vehicle fails the OBD inspection if the “ CHECK
ENGINE ” warning light/MIL is not properly operating
or there is one or more diagnostic trouble codes
stored in vehicle’s computer with the “
CHECK
ENGINE ” warning light/MIL illuminated.
D
A state emission inspection may reject (not pass
or fail) a vehicle if the number of OBD system readi-
ness monitors “
Not Ready ” is greater than three.
Under this condition, the vehicle operator should be
instructed to drive his/her vehicle for a few days to
set the monitors and return for an emission re-in-
spection.
D
Owners of rejected or failing vehicles should con-
tact their Subaru Dealer for service.
Preparing to drive
You should perform the following checks and adjust-
ments every day before you start driving.
1. Check that all windows, mirrors, and lights are
clean and unobstructed.
2. Check the appearance and condition of the tires.
Also check tires for proper inflation.
3. Look under the vehicle for any sign of leaks.
4. Check that the hood, trunk and rear gate are fully
closed.
5. Check the adjustment of the seat.
6. Check the adjustment of the inside and outside
mirrors.
7. Fasten your seatbelt. Check that your passen-
gers have fastened their seatbelts.
8. Check the operation of the warning and indicator
lights when the ignition switch is turned to the “ON”
position.
9. Check the gauges, indicator and warning lights
after starting the engine.
NOTE
Engine oil, engine coolant, brake fluid, washer
fluid and other fluid levels should be checked
daily, weekly or at fuel stops.