Page 19
3-5
#825309 - Revision A - August 2014
Component Access
V-Series Cooktop Hood
V-Series Cooktop Hood
Easy Cube Access
The Easy Cube is located directly above the hood body.
If their is an Internal Blower it is located inside the Easy
Cube. The Power Board Assembly, Light Transformer,
and Hood Electricals are mounted on top of the Easy
Cube.
To Access Area Above Easy Cube:
Note:
The Lower Chimney should not be secured to
the wall in any manner. In instances where the
Lower Chimney has been secured, it is the cus-
tomer’s responsibility to have the Lower
Chimney removed.
1. Extract two screws at bottom of Lower Chimney.
Raise and block Lower Chimney up on Island
Hoods, and remove Lower Chimney on Wall Hoods.
2. The Easy Cube has the control board mounted on
front edge, and unit electricals mounted on back
edge. (See Figure 3-7)
Touch Control Assembly - continued
To Remove Touch Control Assembly - Glass and
Stainless Steel Hoods:
1. Extract two Ribbon Cable screws and disconnect
Ribbon Cable. (See Figure 3-6)
2. Release six tabs retaining Touch Control Assembly
to Hood.
Figure 3-8. Power Board Assembly
Figure 3-7. Wall Hood Easy Cube - Side View
Power Board
Assembly
Unit Electrical
Box
Screws to
Easy Cube
Case Screws
Case Screws
Ribbon Cable
Cover
Power Board Assembly Removal
The Power Board Assembly is located in a black case
attached by two screws to front of Easy Cube.
To Remove Power Board Assembly:
1. Open Ribbon Cable cover with a flat blade screw-
driver and disconnect Ribbon Cable.
(See Figure 3-8)
2. Extract two screws holding Power Board Assembly
case to Easy Cube.
3. Extract four screws holding Power Board Assembly
case together.
4. Disconnect harnesses from Power Board Assembly.
5. Remove three black screws holding Power Board to
Power Board Assembly case.
(See Figure 3-9 - Red Circles)
Primary
Power
12 VDC to
Lighting
12 VDC to
Touch Control
Figure 3-9. Power Board and Transformer
Transformer:
Transformer is located in top cover of Power Board
Assembly case. It is held in with two screws. Orange
wires are 120 VAC to Primary side of Transformer.
Harness in wire sheath is 12 VDC to hood lights.
Connector with gray, black, and white wires is 12 VDC
to Touch Control.
