Page 18
3-4
#825309 - Revision A - August, 2014
V-Series Cooktop Hood
V-Series Cooktop Hood
Component Access
Figure 3-5. Internal Blower in Easy Cube
Figure 3-4. LED Light Assembly
Figure 3-3. Light Assembly Support Removal
LED Light Assembly
Hood lights are LED fixtures that must be replaced as
assemblies. Lights are 12 VDC.
To Remove LED Light Assembly:
1. Extract screws holding Light Assembly Support to
hood. Lower front part of Light Assembly Support
and pull toward center of hood. (See Figure 3-3)
2. Align spring clips to square notches in Light
Assembly Support. Depress spring clips on side of
LED Light Assembly and push through Light
Assembly Support. (See Figure 3-4)
Square
Notches
Spring Clips Spring Clips
Square
Notches
Internal Blower Removal
The 600 cfm Internal Blower is mounted in Easy Cube
portion of hood. Once Filter Covers (Black Hoods) and
Filters are removed Internal Blower can be extracted.
To Remove Internal Blower:
1. Support Internal Blower and extract two screws at
bottom of mounting plate. (See Figure 3-5)
2. Lower Internal Blower from hood. Disconnect
Internal Blower Harness from Internal Blower.
Touch Control
Board
The
t
ouch
c
ontrol
board
is removed differ
e
ntly
for b
lack
h
oods
and
s
tainless
steel/
g
lass
h
oods.
Once
the l
ight
a
ssembly
s
upport is removed
, the
t
ouch
c
ontrol
a
ssembly
case
, which contains the board,
is
accessible
.
R
emove the Touch Control Board - Black Hoods
:
1.
Open the case.
2.
Remove the
two
r
ibbon
c
able screws
,
and
disconnect
the r
ibbon
c
able.
3.
Remove the
two
t
ouch
c
ontrol
board
s
crews
,
and
remove
the t
ouch
c
ontrol
board
.
Touch Control
Screw
Touch Control
Screw
Ribbon Cable
Screws
Figure 3-6. Black Hood Touch Control Board
Internal Blower
Connector
Blower Mounting
Screws
