17
INSTALLING LOGS
Fig. 14 - Installing Log Set
IMPORTANT
: Make sure log does not cover any
burner ports (see Fig. 14). It is very important
to install the logs exactly as instructed. Do not
modify logs. Use only logs supplied with heater.
STEP 1
: Install log 1 onto the two slots in
the rear firebox panel.
All logs
STEP 2
: Install log 2 onto the two slots in middle plate.
STEP 4
: Insert the recessed hole on the
bottom of log 4 onto the pin on log
1, with the other end of log 4
placed on log 2, as shown.
STEP 5
: Insert the recessed hole on the bottom of
log 5 onto the pin on log 2, with the other
end of log 5 placed on log 3, as shown.
1 2 3
5
4
WARNING
: Failure to position the parts
in accordance with these diagrams or failure
to use only parts specifically approved with
this heater may result in property damage
or personal injury.
CAUTION
: After installation, and
periodically thereafter, check to ensure that no
flame comes in contact with any log. With the
heater set to high, check to see if flames
contact any log. If so, reposition logs
according to the log installation instructions
in this manual. Flames contacting logs will
create soot.
STEP 3
: Install log 3 onto the two slots in front plate.
Fig. 13 - Installing Mid Log Bracket
Locate Mid Log Bracket and screws in hardware
package. Attach bracket in burner pan with two
screws. (See Figure 13)
