Style For Life Whole Body Vibration Owner’s Manual • Page 5 of 14
4.
Put the spring washers, slightly rounded washers and
longest bolts
into their corresponding holes, and
secure each bolt into the post by hand. The spring
washers go on to the bolts first.
Make sure the
silver sensors on the bars are facing up. Screw the
handle bar to the stand tube tightly using the
enclosed Allen wrench. See Figure 4. See photo
below for correct parts.
Figure 4
5.
Pull out the plastic cap (23) located inside the stand
tube (19) using a flat head screw driver to expose
the wiring hole on the rear of the stand tube. See
Figure 5.
Figure 5
6.
Run the hand pulse wires (8) and (16) through the
plastic cap (23) and pull them through the hole near
top of the stand tube (19). Press the end cap into the
corresponding hole in the stand tube. See Figure 6.
Figure 6
7.
Connect the leads of the display (12) to the main
connector (11) from stand tube and to the hand
pulse wires from the handle bar (8) and (16). Either
small connector is fine as there is no right and left.
See Figure 7.
Figure 7
