Controls & Features - Front Panel
Mono channels - continued
signal to the MON control is before (or pre) the channel fader, and
before (or pre) the EQ section (HF, MID, LO). Any movement of the
fader will now not change the signal to the MON control. Also any
change to the EQ controls will not change the signal to the MON
control.
This is useful when routing the MON output signal to stage monitors.
11
AUX/DSP control
An auxiliary send to the on board effects processor and to the AUX
SEND output socket. The signal is derived after (post) the channel
fader and allows an independent mix of each channel to the onboard
effect processor. The AUX SEND output can be useful for connecting
external effects processors.
12
PAN control
Adjusts the channels signal between the MAIN MIX (left/right) output. In the
centre position the signals to the MAIN MIX outputs are equal.
13
LISTEN button
When pressed the channel signal will be displayed on the bargraph
meters and can be heard on the headphones & monitor outputs. The
PFL/SOLO modes are described later in this manual.
14
PEAK led
Indicates, by flashing briefly, when the channel signal is approaching
its maximum level. If the led stays illuminated reduce the channel
GAIN control to avoid distortion.
15
MUTE/ALT 3-4 switch
When pressed the channel signal to the MAIN MIX is muted and now
feeds the ALT 3-4 bus.
16
Channel fader
Controls the level of the signal from the channel to the MAIN MIX or
ALT 3-4 bus.
4
www.studiomaster.com
www.studiomaster.com
10
11
12
13
14
15
16
+10
0
-10
-20
-30
8
0 10
L
R
AUX/
DSP
LISTEN
MUTE
/ ALT 3-4
PEAK
1
PRE EQ
PAN
Summary of Contents for Powerhouse 1000X-10
Page 1: ...USER GUIDE...
