INPUTS
Most sound sources can be used with the 1000X although
there are some exceptions.
Some guitars have a very low signal (sound) output, which is
only a problem if maximum sound level is required. If this is
the case, a guitar pre-amplifier will be required to boost the
sound going to the input of the 1000X.
Some microphones, like the types fitted with jack plugs, may
have too low a signal (sound) output. A clue to this is if the
channel and output faders have to be set high or at maximum
to get a good volume level and a hissing sound can be heard
from the loudspeakers. If this is the case the only solution is
to use another microphone preferably one fitted with the
larger XLR type connector.
WARNING : Do not connect the loudspeaker outputs from
amplifiers or hi-fi units to any input. This will cause damage to
the 1000X.
TONE CONTROLS - suggestions
Microphones
HI
set to
MID
set to
LO
set to
CD / MP3
HI
set to
MID
set to
LO
set to
Guitars
HI
set to
MID
set to
LO
set to
Try starting with these settings although there is no substitute
for experimentation.; Remember the tone controls are for
enhancing the sound and do not have to be used.
DSP CONTROLS - to the on board effects processor
A very powerful feature on any mixing console as it gives you
the facility to add effects to your sounds. However, especially
with reverb effects it pays not to use too much as it will tend to
distance the sound(s) it is used on.
LOUDSPEAKERS
Only use speakers of the correct type and rating for the
1000X. Note : The minimum impedance must never be lower
than 4 ohms / channel.
Due to the high audio power the 1000X can deliver, only
heavy duty loudspeakers should be used and not domestic
Hi-Fi types.
Use good quality speaker cables to minimise power loss and
possible damage.
PLAYBACK / RECORD
Generally used for checking recording or playing background
music. However it can be more useful to connect the CD/MP3
playback output to a stereo input channels. This will give you
more control over the sound with its channel fader and tone
controls.
HEADPHONES
The best headphones to use with your 1000X are studio
grade 400 ohm types, although most types can be used but
may not sound as loud.
Headphones are ideal when setting up, recording, playing
back or just getting to know the 1000X controls.
SQUEAL
Correct term 'feedback' occurs when a microphone picks up
sound from loudspeakers connected to the 1000X, increases
the sound level and feeds it back to the speakers - not very
nice! The following points can help reduce this problem:
a)
Keep microphones away from the front of the
loudspeakers.
b)
Don't use too much MID and HI tone control on
channels used with microphones. These controls
tend to boost sounds that can cause feedback.
c)
Microphone technique is important. Encourage the
users to sing/talk directly into and not too far away
from the microphone.
VENTILATION
The 1000X produces heat, especially when used at high
volume levels. It uses small fans to remove this heat.
Don't worry if warm air comes out of the cooling slots on the
rear panel. It's quite normal when used at high volume.
It is important to keep all ventilation slots free from obstruction
for long term reliability. Never place the rear of the unit closer
than 100mm (4") to a wall or object.
SETUP ADVICE
HINTS & TIPS
18
www.studiomaster.com
www.studiomaster.com
Summary of Contents for Powerhouse 1000X-10
Page 1: ...USER GUIDE...
