3
Controls & Features - Front Panel
Mono channels
1
Mic input
3 pin XLR input designed for use with balanced, low impendence
microphones such as the Studiomaster KM range. Global 48V
phantom power is available for condenser microphones - see rear
panel details for the 48V switch location. Can be wired for balanced or
unbalanced
use.
2
Line input
¼” TRS jack socket for balanced or unbalanced line level signals.
Suitable for use with keyboards, drum machines etc. Can be wired for
balanced or unbalanced use.
3
INSERT socket
¼” jack TRS socket enabling the channel signal to be routed to an
external processor (like a vocal compressor) and returned back into
the same channel. The signal to the socket is sourced after the gain
control and before the EQ section.
4
LO CUT switch
A steep low frequency filter that reduces microphone handling noise,
stage rumble and wind noise. Always activate when using a vocal
microphone.
5
GAIN control
Adjusts the incoming signal to match the internal operating level of the
Powerhouse for optimum performance.
6
HI control
Hi frequency control providing 15dB of cut and boost at 12kHz
7
MID controls
Consisting of two controls, the upper provides 15dB of cut and boost.
The lower control sets the frequency of the cut and boost between
500Hz and 5kHz.
8
LO control
Low frequency control providing 15dB of cut and boost at 60Hz
9
MON control
An auxiliary send from the channel routed to the MON fader and then
MON SEND output. An independent mix of all channels can be
created to supply external equipment such as stage monitors. The
source of the signal to the control is set by the PRE switch, see
section
9.
10
PRE EQ switch
In the up position the signal to the MON control is after (or post) the
channel fader. Any movement of the channel fader will also change the
signal to the MON control. This is useful when routing the MON output
to external effects processors. In the down, PRE EQ position, the
1
2
3
4
5
6
7
7
8
9
10
EXPECT THE BEST
EXPECT THE BEST
-
+
-
+
-
+
0 10
LO
60Hz
MON
20dB 60dB
MID
HI
12K
GAIN
500Hz 5KHz
1
PRE EQ
80Hz
MIC
INSERT
LINE
Summary of Contents for Powerhouse 1000X-10
Page 1: ...USER GUIDE...
