10
www.studiomaster.com
www.studiomaster.com
46
Controls & Features - Front Panel
Output section - continued
46
12V LAMP socket
3 pin XLR socket to power a goose neck lamp. Use only with a 12V
4W
lamp.
47
BARGRAPH DISPLAY
a) Power supply status LEDs. Show the +-17V and +5V internal
supplies are working normally.
b) Phantom Power status LED. Illuminates when the Phantom Power
is switched on. The switch is located on the rear panel and applies
+48V to each mic input socket. If Phantom Power microphones are
not used check Phantom Power is switched off.
Do not use unbalanced dynamic microphones when Phantom Power
is on as damage to the microphone may result. Balanced dynamic
microphones should work normally with Phantom Power on however,
if in doubt check with the microphone manufacturer.
c) Left and right bargraphs. Displays the left and right signals
assigned by the PHONES/CONTROL ROOM buttons. See section 51.
48
MON section
a) MON fader. Controls the overall level of signals sent via the input
channel MON controls. This can be used as the master volume
control of the stage monitors.
b) PEAK LED. Illuminates when the MON level is approaching maxi
mum which could result in a distorted sound.
c) LISTEN button. Allows the MON signal to be monitored at the
PHONES/CONTROL ROOM (section 51) and displayed on the left –
right bargraphs. The signal is monitored before (pre) the MON fader.
49
AUX/DSP section
a) AUX/DSP fader. Controls the overall level of signals sent via the
input channel AUX/DSP controls to the DSP (section 43) and AUX
SEND (section 33).
b) PEAK LED. Illuminates when the AUX/DSP level is approaching
maximum which could result in a distorted sound.
c) LISTEN button. Allows the AUX/DSP signal to be monitored at the
PHONES/CONTROL ROOM (section 51) and displayed on the left –
right bargraphs. The signal is monitored before (pre) the AUX/DSP
fader.
50
ALT 3-4 section
a) ALT 3-4 fader. Controls the overall level of signals sent via the input
channels when any MUTE/ALT 3-4 buttons have been pressed. The
signal is then sent to the ALT 3-4 OUTPUT sockets (section 38).
b) PEAK LED. Illuminates when the ALT 3-4 level is approaching
maximum which could result in a distorted sound.
c) TO MAIN MIX. Routes the signals sent via the input channels,
when any MUTE/ALT 3-4 buttons have been pressed, to the left –
right MAIN MIX output. This switch operates independently of the ALT
3-4
fader.
47a
47a
47c
48a
48c
48b
50a
50b
47b
49a
50c
49b
49c
+10
0
-10
-20
-30
8
+10
0
-10
-20
-30
8
LISTEN
LISTEN
PEAK
PEAK
MON
AUX/DSP
MON AUX/DSP
SEND
+10
0
-10
-20
-30
8
PEAK
ALT 3-4
ALT 3-4
TO
MAIN MIX
12V LAMP
+5 PH
+17 -17
+10
+7
+4
+2
0dB
-2
-4
-7
-10
-20
-30
POWER
-40
L - METER - R
Summary of Contents for Powerhouse 1000X-10
Page 1: ...USER GUIDE...
