Studer SW V4.0 OnAir 1000, Operating And Service Instructions

Page: 106 / 361

OnAir 1000 Digital Mixing Console
11-6 Configuration
SW V 4.0 Date printed: 23.10.03
11.2.2 Common Settings
The COMMON SETTINGS page contains the following configuration
possibilities:
CR DIM WHEN AUDITION SEL When the Audition bus is selected as a CR monitoring source, and a CR mi-
crophone input channel is ON, the CR monitor speaker level will be attenuated
(DIM), muted (CUT), or nothing happens at all (DON'T CARE).
PFL CUT ON CH. ACTIVE If YES is selected, the signal of a channel is taken off the PFL bus when
the channel is ON, although the PFL function is active (the PFL function
remains active).
ON AIR INDICATION Three possibilities are available:
Σ
PROGRAM,
Σ
RECORD, or
Σ
PROG-
RAM AND
Σ
RECORD.
The ON-AIR signaling is only active if at least one channel is ON, if this
channel's fader is open, and if this channel is assigned to the selected bus
(
Σ
PROGRAM,
Σ
RECORD, or either of them).
In automation operation, ON-AIR is continuously scrolling in the channel
label of the input channel selected by the automation system. FADER-
STATUS is ON-AIR if the input channel is assigned to the selected bus
(
Σ
PROGRAM,
Σ
RECORD, or either of them).
KEY FUNCTIONS Functions of the channel keys labeled ON and OFF.
The ON key either switches the input channel ON or has an ON/OFF tog-
gle function, depending on the function selected for the OFF key.
If the OFF function is selected for the OFF key, the input channel is
switched off by pressing this key; if LOCATE is selected, the ON function
automatically changes to a channel ON/OFF toggle function (also refer to
chapters 8.2 and 8.3 ).
DEFAULT MASTER LEVEL: The level of the PGM and REC master outputs can be biased in a range of
–7 to +5 dB using the two rotary encoders below the corresponding fields.
This setting is only valid if no fader strips are assigned to the
Σ
PGM
and/or
Σ
REC outputs; please note that this setting must be done with care,
as it directly affects the level of the main outputs.
Note: The MASTER FADER ASSIGNMENT function for PGM and REC mas-
ter outputs that was available on this page in earlier software versions has
been moved. Activation and deactivation of the PGM and REC master fad-
ers is performed on the CHANNEL ROUTINGS page now; please refer to
chapter 5.14 .