Stryker PneumoSure, Service Manual, Page: 68 / 76

66
EN
Replacing Components and Modules
1. Open the device as described in chapter 3.6 Opening the Device .
2. Remove device front panel as described in chapter 6.14 Uninstalling/Install-
ing Device Front .
3. Remove tube connection as described in chapter 6.15 Uninstalling/Installing
Tube Connection.
4. Uninstall the MIO board MIO LCD as described in chapter 6.8 Uninstalling/In-
stalling MIO/Board MIO LCD .
5. Remove adhesive copper tape
(12)
from device front.
6. Carefully press the six catches (plastic)
(11)
into the frame so that the face-
plate (plastic) can be removed from the device front.
7. Remove the light sensor
(5)
from the faceplate.
8. Remove tube detection as described in chapter 6.16 Uninstalling/Installing
Tube Detection, page 61 .
9. Remove the angle square
(1)
and carefully lift the touch display off from the
device front.
10. Follow these steps in reverse for assembly.
Follow these steps to install a touch display:
1. Flip the latch (14) up and insert the LCD flat ribbon cable (13) with the blue
marking
(15)
pointing up into the latch. Flip latch down to fix flat ribbon ca-
ble in place.
2. Carefully shape the LCD flat ribbon cable
(10)
by bending according to Fig. 6-
42 Flat ribbon cable LCD .
3. Place the touch display on the front panel and align with the help of the me-
tallic stops
(6)
and the clamping angle square
(1)
. Use a size SW5.5 jaw
wrench to tighten the screw of the angle square
(1)
.
4. Remove the protective foil from the touch display.
5. The light sensor is inserted through the front opening and fastened to the
faceplate with black adhesive cloth tape (see Fig. 6-45 Light sensor fastening).
6. Attach faceplate to front.
The following tests/calibrations must be performed after installing a new touch
display:
• Basic function test
• Touch display calibration
• Leak test (see chapter 4.8 Testing the Low Pressure Unit LPU for Leaks)
• Safety test (see chapter 4.1 Safety Test)