Stryker PneumoSure, Service Manual, Page: 63 / 76

Replacing Components and Modules
61
EN
6.16 Uninstalling/Installing Tube Detection
DANGER!
Disconnect device from power supply.
1. Open the device as described in chapter 3.6 Opening the Device .
2. Remove device front panel as described in chapter 6.14 Uninstalling/Install-
ing Device Front .
3. Remove tube connection as described in chapter 6.15 Uninstalling/Installing
Tube Connection.
4. Uninstall the MIO board MIO LCD as described in chapter 6.8 Uninstalling/In-
stalling MIO/Board MIO LCD .
5. Remove adhesive copper tape from device front (see Fig. 6-43 Remove face-
plate, page 65).
6. Carefully press the six catches (plastic) into the frame so that the faceplate
(plastic) can be removed from the device front (see Fig. 6-43 Remove face-
plate, page 65).
7. Remove the light sensor from the faceplate (see Fig. 6-40 Position of touch
display, page 64).
8. Remove the ST6 plug/cable leading to the tube detection
(4)
from the IMO
Fig. 6-35 Position of tube detection
(1)
Micro switch
(2) Tube detection holder
(3)
1x fastening screw
(4) ST6 plug/cable leading to MIO
board
(4) (3) (2) (1)
Fig. 6-36 Adjusting the trigger sensitivi-
ty
(5) Plunger
(6)
Micro switch
(7) Locknut screw
(8)
Setting screw
(6) (7)
(5)
(8)