Stryker IsoAir, Maintenance Manual, Page: 32 / 94

P Po ow we err ssu up pp pllyy rre ep plla acce em me en ntt
T To oo ollss rre eq qu uiirre ed d::
• ESD system
• #2 Phillips screwdriver
P Prro occe ed du urre e::
1. See Separate the front and back covers (page 22).
C CA AU UT TIIO ON N
• Always use ESD protective equipment before you open antistatic bags and service electronic parts.
• Do not place unprotected circuit boards on the floor.
2. Unplug the inlet power cord assembly from the power supply CN1 (two wire cable).
3. Using a #2 Phillips screwdriver, remove the four screws (S) that secure the power supply (N) to the main support plate
(R) (Figure 24). Save the screws.
R
S
N
F Fiig gu urre e 2 24 4 –– P Po ow we err ssu up pp pllyy tto o m ma aiin n
4. Remove and discard the power supply (N) (Figure 24).
N No otte e -- Do not dispose of as unsorted municipal waste. Refer to your local distributor for return or collection systems
available in your country.
5. Reverse steps to install the new power supply.
6. Reconnect the support surface.
7. Run a diagnostics and full function test before you return the product to service.
EN 30 2941-109-002 Rev AA.0