Stryker 7600-000-050, Maintenance Manual

Page: 26 / 78

• Torque wrench with 5 mm hex bit (9.5 Nm)
• 5 mm hex wrench
• Needle nose pliers
• Hammer
P Prro occe ed du urre e::
1. Put the brake in the neutral position.
C CA AU UT TIIO ON N -- With the brake in the neutral position, the product could move.
2. Raise the product to the highest height position.
3. Unplug the power cord from the wall outlet.
4. Using needle nose pliers, remove and discard the rue ring cotter pin (G) from the hex shaft (Figure 7).
5. Pull the brake pedal off the hex shaft and set aside (Figure 7).
6. Remove and save the plastic washer (H) that is on the hex shaft (Figure 7).
7. Using a hammer and a large screw driver, remove and discard the starlock retainer (K) that is on the hex shaft (Figure
7).
8. Using a 5 mm hex wrench, remove and discard the two screws (I) and washers (J) that secure the non-steer caster to
the base frame (Figure 7).
9. Use a small floor jack to lift the base frame cross tube to loosen the non-steer caster.
10. Grasp the opposite brake/steer pedal and pull outward about four inches (100 mm) to remove and discard the non-steer
caster.
N No otte e -- Note the position of the label on the mounting shaft of the old caster for reinstallation of the replacement caster.
11. Reverse steps to reinstall.
W WA AR RN NIIN NG G -- Always make sure to line the hex shaft with the hex in the caster. Test the caster to identify the direction of
the brake. Damage may occur if you install the caster incorrectly.
N No otte e -- Torque the caster mounting screws (I) to 9.5 Nm +/- 1.5 Nm.
12. Verify proper operation of the product before returning it to service.
EN 22 SK-7600 REV 06