Stryker 6516, Operation Manual

Page: 38 / 70

A
B
F Fiig gu urre e 1 14 4 –– A Aiirrb bo orrn ne e™ ™ ssiid de e--b byy--ssiid de e iin nccu ub ba atto orr
SIDE VIEW
A
B
F Fiig gu urre e 1 15 5 –– L La attcch h tta ab bss -- ssiid de e vviie ew w
IIn nsstta alllliin ng g tth he e D Drra ag ge err iin nffa an ntt ttrra an nssp po orrtt iin nccu ub ba atto orr a ad da ap ptto orr
W WA AR RN NIIN NG G
• Do not install these incubator adaptors on any other Stryker cot or on any cot from another manufacturer. These
incubator adaptors are for use only on the P Po ow we err--P PR RO O IT cot.
• Always make sure that the incubator adaptor is properly installed on the cot and the incubator is securely fastened to the
incubator adaptor before use.
• Stryker is not responsible for specification changes to the D Drra ag ge err® (or A Aiirr--S Sh hiie elld dss® Series) incubators.
Before you install an incubator on the P Po ow we err--P PR RO O IT cot, read and understand this manual and the manual that was
supplied with the incubator.
To install the incubator adaptor ( Installing the Drager infant transport incubator adaptor (page 34)):
1. Pull the red latch handle (A) on the incubator adaptor and move it to the right until the slot in the handle catches with the
shoulder bolt (B) on the incubator adaptor.
2. Place the incubator on the incubator adaptor. Align the holes in the incubator with the four pins (C) on the incubator
adaptor. Only two of the four pins are shown.
3. Move the latch handle (A) to the left to release it. The handle retracts and the latches secure the incubator.
4. Inspect all four locking points. Make sure that the latches are secure and not obstructed by anything, such as hoses or
wires.
EN 34 6516-209-001 Rev D.0