Stryker 297300000000, Maintenance Manual

Page: 26 / 76

S Se errvviicce e
P Prro otte eccttiin ng g a ag ga aiin nsstt e elle eccttrro osstta attiicc d diisscch ha arrg ge e ((E ES SD D))
C CA AU UT TIIO ON N
• Always use ESD protective equipment before you open antistatic bags and service electronic parts.
• Do not place unprotected circuit boards on the floor.
N No otte e -- Always ship the circuit boards back to Stryker. Use the antistatic bag that the new board was originally shipped in.
The electronic circuits in the product are completely protected from static electricity damage when factory assembled.
Always use adequate static protection when you service the electronic systems of the product. All service personnel must
use static protection whenever they touch wires.
Sample antistatic protection equipment includes:
• Antistatic wrist strap
• Grounding plug
• Test lead with a banana plug on one end and an alligator clip on the other end
Make sure that you follow the ESD manufacturer’s instructions for appropriate protection against static discharge.
C Co ovve err rre ep plla acce em me en ntt,, tto op p
T To oo ollss rre eq qu uiirre ed d::
• Zipper pull tool or equivalent
P Prro occe ed du urre e::
1. Apply the brakes on the P Prro oC Cu uiittyy bed frame.
2. Unplug the support surface power/data cable from the bed.
3. Remove the power/data cable from the strain relief bracket.
4. Remove the headboard and footboards.
5. Lower all the siderails.
6. Unsnap the two secure snaps (C) at the foot end corners (Figure 1).
7. Unsnap the four corner retainers (B) (Figure 1).
N No otte e
• On install, reconnect the corner retainers. Place the strap below each D-ring at the foot end corners and snap the
cover.
• The zipper starts on the patient right side near the foot end.
EN 22 2973-009-002 Rev AB.0