Stryker 2941-000-001, Maintenance Manual

Page: 19 / 88

S Se errvviicce e
A Acccce essssiin ng g tth he e d diia ag gn no ossttiicc m mo od de e
W WA AR RN NIIN NG G -- Always plug the power cord into the bed auxiliary outlet or a grounded power respectable. Do not use an
extension cord.
1. Plug the support surface hoses into the pump. Remove all weight from the support surface.
2. Power on the pump.
3. As the software loads, press the O ON N button within five seconds (Figure 1), press, and hold the A Accttiio on n button next to the
H Ho om me e icon (Figure 2).
IsoAir
F Fiig gu urre e 1 1 –– S So offttw wa arre e llo oa ad diin ng g F Fiig gu urre e 2 2 –– S Se errvviicce e ssccrre ee en n h ho om me e
4. Press the A Accttiio on n button next to the S Se errvviicce e icon to start the diagnostic mode (Figure 3).
F Fiig gu urre e 3 3 –– S Se errvviicce e ssccrre ee en n e en nttrryy
IsoAir
F Fiig gu urre e 4 4 –– D Diia ag gn no ossttiicc m mo od de e a an nd d sso offttw wa arre e vve errssiio on n
N No otte e -- The software version is located on the service screen (Figure 4).
5. Review the diagnostic result.
a. If the diagnostic result is OK, the test passes.
b. If the diagnostic result is not OK, investigate the diagnostic test result.
P Prro otte eccttiin ng g a ag ga aiin nsstt e elle eccttrro osstta attiicc d diisscch ha arrg ge e ((E ES SD D))
C CA AU UT TIIO ON N
• Always use ESD protective equipment before you open antistatic bags and service electronic parts.
• Do not place unprotected circuit boards on the floor.
N No otte e -- Always ship the circuit boards back to Stryker. Use the antistatic bag that the new board was originally shipped in.
2941-009-002 Rev B.0 15 EN