Stryker 1188-010-000, User Manual

Page: 43 / 752

EN-39
Electromagnetic Compatibility
Like other electrical medical equipment, the 1188HD Camera requires special
precautions to ensure electromagnetic compatibility with other electrical medical
devices. To ensure electromagnetic compatibility (EMC), the 1188HD Camera
must be installed and operated according to the EMC information provided in
this manual.
Note The 1188HD Camera has been designed and tested to comply
with IEC 60601-1-2 requirements for EMC with other devices.
Caution Equipment which employs RF communications may affect the
normal function of the 1188HD Camera.
Warning Do not use cables or accessories other than those provided
with the 1188HD Camera, as this may result in increased
electromagnetic emissions or decreased immunity to such
emissions.
Warning If the 1188HD Camera is used adjacent to or stacked with
other equipment, observe and verify normal operation of the
1188HD Camera in the configuration in which it will be used
prior to using it in a surgical procedure. Consult the tables
below for guidance in placing the 1188HD Camera.
Guidance and Manufacturer's Declaration: Electromagnetic Emissions
1188HD Camera is intended for use in the electromagnetic environment specified below. The
customer or the user of 1188HD Camera should ensure that it is used in such an environment.
Emissions test Compliance Electromagnetic Environment - guidance
RF emissions CISPR
11
Group 1
1188HD Camera uses RF energy only for its
internal function; therefore, its RF emissions are
very low and are not likely to cause any
interference in nearby electronic equipment.
RF emissions CISPR
11
Class A
The 1188HD Camera is suitable for use in all
establishments other than domestic
establishments and those directly connected to
the public low-voltage power supply network
that supplies buildings used for domestic
purposes, provided the following warning is
heeded:
Warning: This system is intended for use by
healthcare professionals only. This system may
cause radio interference or may disrupt the
operation of nearby equipment. It may be
necessary to take mitigation measures, such as
reorienting or relocating the system or shielding
the location.
Harmonic emissions
IEC61000-3-2
Class A
Voltage Fluctuations/
flicker emissions
IEC61000-3-3
Complies