Strongline MEG1000i, Instruction Manual

Page: 75 / 84

74
4. Remove any dirt from around the spark plug base.
5. With the spark plug wrench provided remove the spark plug (Fig.V).
6. Visually inspect the spark plug. Remove carbon deposits using a wire brush.
7. Check for discoloration on the top of the spark plug. The standard colour should be a
tan colour.
8. Check the spark plug gap. The acceptable gap should be between 0.6–0.7mm.
(Fig.W).
9. Install/reinstall the spark plug carefully by hand.
10. Once the spark pug has been seated tighten with the spark plug wrench.
11. Reinstall the spark plug cap on top of the spark plug.
12. Reinstall the spark plug maintenance cover (11), and Reinstall handle.
The recommended spark plugs are as follows: NGK CR7HSA
27
、
、 、
、
Engine oil replacement
1. Place the generator on a level surface and warm up the engine for several minutes. Then stop the engine.
2. Loosen the side maintenance cover screw (3) and remove the side maintenance
cover.
3. Remove the oil filler cap (24).
4. Drain dirty oil into a container thoroughly by tilting the engine toward the oil filler
neck.
5. Once emptied, tilt the generator back up and place into the generator up right
position.
6. Refill with recommended oil. Fill to the upper limit of the filler neck (Fig.X).
Fig. W