Strongline MEG1000i, Instruction Manual

Page: 67 / 84

66
21
、
、 、
、
AC Applications
1. Start the engine. Make sure the green output indicator light (18) comes on (it may take up to 3 seconds). Allow the motor
to run for a couple of minutes to warm up prior to connecting any apparatus to the generator.
2. Ensure the apparatus/appliance switch is turned OFF. Then plug the power cord into the AC output socket (19) on the
generator.
Note. Before connecting an apparatus/appliance make sure that.
●
The apparatus/appliance is in good working order. Faulty appliances or power cords can create a potential electrical
shock.
●
It is highly recommended to have a surge protector connected to the generator at all times.
●
Check to make sure that the apparatus/appliance does not exceed that of the generator. Never exceed the maximum
power rating of the generator.
3. Switch the AC Smart Throttle System (15) if required to the ‘ON’ position (Fig.N)
Smart Throttle:
●
The Smart Throttle System does not operate effectively if the electrical
appliance requires the momentary electric power.
●
When operating high electrical loads simultaneously turn the Smart Throttle System switch to the OFF position to
reduce voltage change.
Overload Indicator
When the generator has an output required that exceeds it’s output an overload indicator light (17) will glow, providing a
warning before cutting the engine out 20 seconds later.
CAUTION.
Ensure the electric apparatus is turned off before plugging in. Ensure that the total load is within the generator rated output.
Fig. N