Scan mode
:
Select
All
to store scrambled and free to air channels or select
Free
to store only free to
air channels. Note: Scrambled channels cannot be viewed with this receiver.
Connection
:
Use this option to adjust the established connection to your TV set. Select
HDMI
or
TV
SCART
.
*Availability of DVB/HoH subtitles depends on the broadcast. If such subtitles are not supported, then
most likely subtitles can be activated via Teletext if available.
When all settings have been made, move the highlight to
OK
and press
Ok
to continue.
NOTE:
Wrong region selection can lead to missing channels or channels being stored at
wrong positions in the channel list.
The receiver will now advance to the
Aerial Adjustment
screen.
This part of the wizard is of great help when setting up your antenna system.
Use
pq
to move the highlight to the setting you wish to alter and use
tu
to change values. The
following settings are available:
Antenna Power
: Set to
On
if you use an active antenna. When set to
On
, 5 V will be present at the ANT
IN connector of the receiver. Select
Off
for passive antennas.
Beeper
:
Select
On
for an audible indication of signal reception.
Off
turns the beeper off.
Channel No.
:
Select a channel that is known to carry a broadcast in your region. The
Signal Strength
and
Signal Quality
bars give a visual indication of the reception. Adjust your antenna to
obtain maximum signal strength and quality.
When all settings have been made, press
Ok
to start scanning.
The receiver will search for all available channels now. Once scanning is finished, the receiver switches to
viewing mode.
TIP:
If the
Welcome
menu does not appear after switching on the receiver the first time,
reset the receiver to factory settings by pressing the
MENU
button and selecting
Load Factory Setting
in the submenu
Tools
.
(DEfaUlT PIN: 1234)
.
5.0 QUICk GUIDE TO USING YOUR RECEIvER
We at STRONG understand that you can’t wait to enjoy your new high definition digital terrestrial
receiver. The following quick guide will make you familiar with the basic operation of this device. We do,
however, advice you to read the full manual to get the best performance from your receiver.
To turn your receiver ON or to Standby, use the
q
button on the remote control.
Choose the desired channel with the
pq
buttons. Alternatively, you can digit the channel number with
the
0~9
buttons on the remote control or press
Ok
in viewing mode to display the channel list. The
volume can be adjusted with the
tu
buttons.
6.0 OPERaTION
Your new receiver is equipped with several features to make watching TV a true pleasure. This paragraph
describes these features. Please also read chapter
7.0
to get familiar with the menu of your receiver.
6.1 Changing channels
Following ways are possible for changing channels with your new receiver:
Via direct access using the
0~9
buttons.
Via the channel list through
Ok
and the
PG+/PG-
buttons.
Via the
pq
buttons.
6.1.1 Direct access via 0~9 buttons
To gain direct access to a certain channel, simply input its number with the
0~9
buttons on the remote
control. Channel numbers can be up to four digits long. Entering a number with less than four digits
6
PaRT 1 • English
