Strong SRT 5016, User Manual

Page: 17 / 20

PART 1 • English
14
Symptom Remedy
General
Standby indicator on
front panel does not
light up Check if power is available at the wall socket. Check if the SCART cable
and antenna cable are correctly connected and the receiver is switched on.
Disconnect these cables, and reconnect them to ensure they are in place
Standby indicator on
front panel is red Your receiver is in standby, press the power button on your remote control
Remote control fails to
operate receiver Check the batteries in your remote control. Make sure your receiver is in
the operate mode. Make sure you are pointing your remote control at the
receiver’s front panel
Make sure there is no direct sunlight from behind the receiver
There may be a temporary transmission error, or your receiver has lost
some of its software settings. Switch off your receiver at the power source
and switch it on again after a few seconds
No program broadcast
recorded on VCR Check the connection between receiver and VCR. Please make sure your
VCR is set properly
Electronic Program Guide (EPG)
EPG empty The selected program does not support EPG. The local time is incorrect.
Set the correct local time
Audio & video issues
TV Picture changes
colour This may happen after a power-cut or disconnection from the power source.
Your receiver has lost some software settings. Switch off your receiver and
on again after a few seconds. If the problem persists, contact your vendor
Blocks in the TV picture The signal is too weak or defective due to e.g. bad weather conditions. Try
to adjust your aerial position or wait for the signal to be re-established
A.2 SPECIFICATIONS
Demodulator
Demodulator: COFDM; 16 QAM / 64 QAM
Transmission mode: 2 K ~ 8 K
Video Decoder
Profile level: MPEG2 MP@ML
Video resolution: 720 x 576 pixels (PAL), 720 x 480 (NTSC)
Decoding & Video Out: PAL & NTSC
Aspect ratio: 4:3, 4:3 FULL, 16:9