2.6 Using the remote control
Use the remote control by pointing it towards the remote sensor. Items between the remote
control and the remote sensor could block normal operation.
Do not cause the remote control to vibrate violently. Also, do not splash liquid on the remote
control, also do not put the remote control in a high humidity place.
Do not place the remote control under direct sunlight which will cause deformation of the unit
by heat.
When the remote sensor is under direct sunlight or strong lighting, the remote control will not
work. If so, please change the lighting or TV's position, or operate the remote control closer to
the remote sensor.
3.0 FIRST TIME INSTALLATION
After all connections, have been properly made, switch on your TV.
NOTE:
The first time you switch on your TV, the installation procedure will start
with
First Time Installation Menu
(see chapter
3.1.1
).
3.1 Select Input Source
Select which input source you want to use:
Press
Source
to display the input source list. Press
pq
to select the input source and confirm by
pressing
OK
.
3.1.1 First Time installation menu
To access the menu of first installation press
Menu
and use
t
u
to select
Setup
. Press
pq
to select
First
Time Installation
and confirm with
OK
.
Language:
Press
t
u
to select the language to be used for menus and message.
Country
Press
pq
to highlight the
Country
menu. Press
t
u
to select your country.
3.1.2 Tuning Setup
Press
OK
to set the
Tuning Setup
menu.
Tune Type
Select
DTV
for digital signals,
ATV
for analogue signals or
DTV+ATV
for both.
(Digital Type only available for DVB-T and DVB-C)
Digital Type
Select
Satellite DVB-S
for signals from a satellite dish (LNB),
Terrestrial DVB-T
for
signals from terrestrial antenna or
Cable DVB-C
for signals from cable.
3.2 DVB-S installation
Satellite Setting
First select the
Digital Type
by pressing
t
u
to select Satellite (DVB-S) for satellite broadcasts. Then use
pq
to select the following settings:
Satellite
Press
t
u
to highlight the satellite your dish is aimed at.
Scan Mode
Press
t
u
to select
Default
,
Blind Scan
or
Network
7
English
