Strong Racks PowerRax Double Bike Lift, Manual

Page: 15 / 33

6
To assemble the Swing-Arm: slide the connector tube into the Upper Swing-arm tube and slide
the Lower Swing-arm tube onto the connector tube.
Using your measurement from the
previous page: lay your tape measure from the hole on the Upper Swing-arm tube along the side
of the tubes and adjust until you are 1” to 3” less than your measurement (this will ensure when
the arm swings down it will have a gap from the floor).
15
For maximum extension, the connector tube should have 6 holes inside each of the upper and lower
swing-arm tubes – this should never be exceeded.
Before
After
1” to 3”
for gap
Upper/Lower
Connector
1 2 3 4 5 6