Strobel VTD410EV-SEPC1, Operating Instructions Manual

Page: 25 / 36

21
BA_VTD410EV-SEPC1_A1_140417_en
5 Operating the machine
The machine is operated with an electronic-pneumatic control. The operation is
very easy:
5.1 Right hand treadle
By means of the right hand treadle the motor is operated, the front cup is
opened and the needle is positioned.
The process is as follows:
- Usually the front cup is opened.
- Insert the material.
- Press the pedal forward slightly (pedal po1/2), pressure plate is
closed.
- Press the pedal further to the front (pedal position
≥ +1), machine sews all
the faster the further the pedal is pressed forward.
- Return pedal to idle position (pedal position 0), machine stops in the
needle position 1 (the needle now stands about 10 mm in front of the
transport plate). (See also point “5.2 Operating the gathering device (EV)”
- “5.2.2 Gathering (left hand treadle)”)
- Press pedal all the way back (pedal position -2), machine moves to needle
position 2 and the pressure plate is opened (the needle stands with the tip
about 4 mm within the transport plate).
5.2 Operating the gathering device (EV)
If the pneumatic gathering device is needed to gather extra fullness, e.g. at the
toe part, stop the sewing process at the previously determined point - as
described in point “5.1 Right hand treadle” the needle is now in the material and
keeps it in this position (Fig. 13).
Fig. 13
Keep insole and upper apart in a way that the gathering device can swivel down
between the two parts.